Panasonic PN261693D Manual page 176

R Resets the value of a counter.
Press R, and then the value of the counter is reset. The appearance is switched to the dis-
play from a counter reset.
F Configures the update mode of the screen.
Press F, and then the appearance of the command prompt becomes "Select refresh mode
>". Press 1 to stop the automatic update, and 2 to change the update interval. If you enter
2, the appearance of the command prompt becomes "Input refresh time>". Enter the
integer in the range from 5 to 600 (seconds).
Q Returns to the top menu.
In addition, this screen shows two kinds of cumulative (Figure 5-1) from a counter
reset and the cumulative (Figure 5-1), which is set after starting this device. After
reseting a counter, the cumulative (which is set after starting) is saved.
PN262492 Local Management System
Main Menu -> Statistics Menu
Port: 1
<Counter Name>
Total RX Bytes
Total RX Pkts
Good Broadcast
Good Multicast
CRC/Align Errors
Undersize Pkts
Oversize Pkts
Fragments
Jabbers
Collisions
64-Byte Pkts
65-127 Pkts
128-255 Pkts
256-511 Pkts
512-1023 Pkts
Over 1024 Pkts
-------------------------------- <COMMAND> -----------------------------------
[N]ext [P]revious [S]elect Port Re[f]resh Mode Since [R]eset [Q]uit
Command>
Enter the character in square brackets to select option
Figure 5-1 B: Displaying the Cumulative from a Counter Clear
Screen Description
Port
Refresh
Elapsed Time Since
System Reset
Counter Name
Total
Avg./s
Refresh: 300 Sec.
<Total>
0
0
0
0
0
0
0
0
0
0
0
0
0
0
0
0
Displays the port-number.
Displays the update interval of the screen. The factory default settings is 300
seconds.
Displays the time passed after a counter is reset.
Displays the name of each counter.
Displays the value of each counter.
Displays the average value for one second of each counter.
Elapsed Time Since System Up: 000:00:00:00
<Avg./s>
0
0
0
0
0
0
0
0
0
0
0
0
0
0
0
0
176