Pps Port Configuration - Panasonic PN261693D Manual

4.12.3. PPS Port Configuration

Press P (command) on the screen of the PPS Configuration, and then you can see
the "PPS Port Configuration" as Figure 4-55. You can perform the PPS port-con-
figuration on this screen.
PNxxxxxx Local Management System
PPS Configuration -> PPS Port Configuration
Port Trunk Link State
---- ----- ---- ---------- --------- --------
1 --- Down Forwarding 128
2 --- Down Forwarding 128
3 --- Down Forwarding 128
4 --- Down Forwarding 128
5 --- Down Forwarding 128
6 --- Down Forwarding 128
7 --- Down Forwarding 128
8 --- Down Forwarding 128
9 --- Down Forwarding 128
10 --- Down Forwarding 128
11 --- Down Forwarding 128
12 --- Down Forwarding 128
-------------------------------- <COMMAND> -----------------------------------
[N]ext Page
[P]revious Page
Command>
Enter the character in square brackets to select option
Screen Description
The following describes how to use several commands on this screen.
Port Displays the port-number.
Trunk Displays the condition (or status) of the trunking configuration with a group number.
Link Displays a current link condition (or status).
Up
Down
State Displays a current port condition (or status).
Forwarding
Learning
Discarding
AdminPri. Displays the priority to use for automatically determining the communication path of
the PPS configured per port. The factory default settings is 128.
OperPri. Displays the priority to automatically determine the communication path of the PPS,
which is assigned per port.
AdminPri. OperPri.
128
128
128
128
128
128
128
128
128
128
128
128
Figure 4-55: PPS Port Configuration
UP indicates that a link is normally established.
DOWN indicates that a link is not established.
Indicates the condition that the normal communication runs (or works)
as a result of calculations.
Indicates the condition that computations are performed (or operated)
based on information.
Indicates the condition that computations are not performed.
Set PPS [A]dmin Priority
[Q]uit to previous menu
166