Table of Contents
Advertisement
The following describes how to use several commands on this screen.
V
Configures an ID of remote VLAN.
1. Press V (command), and then the appearance of the command prompt becomes
"Seletct source or destination remote vlan (S/D)>". Press S to configure the remote
VLAN of the source session, and D to configure remote VLAN of the destination ses-
sion.
2. Press S or V, and then the appearance of the command prompt becomes "Enter
Remote VLAN ID(2-4094)>". Enter the ID of remote VLAN in the range from 2 to
4,094.
S
Configures a source port that will be monitored.
Press S, and then the appearance of the command prompt becomes "Seletct port or trunk
to modify (P/T)>". Press P for a normal port, and T for a trunk port. Enter the port-number
as the next target.
T
Configures the communication direction of target packets to be monitored.
Press T, and then the appearance of the command prompt becomes "Select traffic
direction(R/T/B)>". Press R to set to RX, T to set to TX, and B to set to both.
D
Configures the port of the destination of transferring data (ports for connecting to an ana-
lyzer) monitored.
Press D, and then the appearance of the command prompt becomes "Seletct port or
trunk to modify (P/T)>". Press P for a normal port, and T for a trunk port. Enter the port-
number as the next target.
C
Configures a port of the destination of transferring data that will be monitored (ports for con-
necting to analyzers).
Press C, and then the appearance of the command prompt becomes "Enter CPU RX
Monitor Status (Y/N)>". Press P for a normal port, and T for a trunk port.
A
Configures the condition of the CPU-receiving mirror.
Press S, and then the appearance of the command prompt becomes "Seletct port or
trunk to modify (P/T)>". Press P for a normal port, and T for a trunk port. Enter the port-
number as the next target.
Q
Returns to the top menu.
-------------------------------------------------------------------------------------------------------------------------------------------
Note: The VLAN tag of VLAN ID received is added on the mirror packet whose direc-
tion is Tx.
-------------------------------------------------------------------------------------------------------------------------------------------
-------------------------------------------------------------------------------------------------------------------------------------------
Note: The management packets (e.g. Ping and ARP), which are transmitted from this
device, cannot be captured.
-------------------------------------------------------------------------------------------------------------------------------------------
90
Advertisement
Table of Contents
