Table of Contents
Advertisement
Do the following procedure on the screen.
① Type manager on a user-name column, and then press Enter.
Log-in name as Figure 2-1:
The log-in name is set to manager for the factory default settings.
② As Figure 2-1, type manager on a password column, and then press
Enter.
Password:
The password is set to manager, which is the same with the log-in name for
the factory default settings.
③ Enter the log-in name and the password accurately as Figure 2-1, and then
FA-MLxxTPoE+> is displayed.
If the password or log-in name is incorrect, GA-MLDxxTPoE+> is not dis-
played.
You can change the log-in name and password. See the configuration of access
condition for details on the method of changing (System Security Configuration).
UserName:manager
Password:xxxxxxx
GA-MLDxxTPoE+>
Figure 2-1: Entering a User Name and Password
-------------------------------------------------------------------------------------------------------------------------------------------
Note: All of the passwords are displayed as "*".
-------------------------------------------------------------------------------------------------------------------------------------------
-------------------------------------------------------------------------------------------------------------------------------------------
Note: For Telnet, four users can access concurrently (and maximally).
-------------------------------------------------------------------------------------------------------------------------------------------
GA-MLDxxTPoE+
Command Line Interface
Product Number: PNxxxxxx
Firmware Version: V2.0.1.00
MAC Address: 00:50:40:xx:xx:xx
Serial Number: xxxxxxxxxxx
9
Advertisement
Table of Contents
