Table of Contents
Advertisement
Screen Description
Console UI Idle
Displays time as the minute unit until a session exits if nothing is entered and a
Time Out
console is connected. The factory default settings is three (3) minutes.
Telnet UI Idle
If remote connection is operated with Telnet, the screen will display the time
Time Out
needed as a minute-unit until a session is disconnected if nothing is entered.
The factory default settings is three (3) minutes.
Telnet Server
Displays if the access with Telnet works. The factory default settings is set to
Disabled.
Enabled:
Disabled:
SNMP Agent
Displays if the access with SNMP works. The factory default settings is set to
Disabled.
Enabled:
Disabled:
Web Server
If a function of WEB authentication is enabled on CLI, it becomes changed to
Status
Enable automatically. If Web Server Status becomes disabled, be careful with
that as the function of WEB authentication is not used. Use CLI when configuring
the function of WEB authentication. The factory default settings is set to
Disabled.
Enabled:
Disabled:
IP Setup
Displays if the access with the software of the IP address configuration, which is
Interface
included in a network camera produced by Panasonic and "ZEQUO assist Plus"
as a support tool of our switching hub, is possible. The factory default setting is
"Enabled". Note: See section 3.5.3 for the caveats.
Enabled:
Disabled:
Local User Name Displays the user-name, which is configured currently to log in. Manager is set to
the factory default settings. Use CLI when changing a user name.
Syslog
Displays if the system log is transmitted to Syslog servers.
Transmission
The factory default settings is set to Disabled.
Enabled:
Disabled:
Login Method 1
Displays a user-name, which is currently configured to log in.
The factory default settings is local.
Local
RADIUS
Login Method 2
Displays how to check a user-name and a password that are used to log in. The
factory default settings is None.
Local
None
Accessible
Inaccessible
Accessible
Inaccessible
Accessible
Inaccessible
Accessible
Inaccessible
System log is transmitted to the Syslog server.
System log is not transmitted to the Syslog server.
Log in to your device using a user name and a password config-
ured.
Use an authentication operated by the RADIUS server to log in.
Log in to your device using a user name and a password.
The login method 2 is not used.
37
Advertisement
Table of Contents
