Table of Contents
Advertisement
The following describes how to use several commands on this screen.
C
Designates a VLAN ID.
Press C (command), and then the appearance of the command prompt becomes "Choose
VID (1-4,094)> ". Enter a VLAN ID.
S
Configures the Querier status (or condition).
Press S, and then the appearance of the command prompt becomes "Enable or Disable
querier status (E/D)>". Press E to enable and D to disable it.
V
Configures the query version for transmitting with Querier.
Press V, and then the appearance of the command prompt becomes "Enter IGMP version
(1/2/3)>". Enter the version of queries for sending with the IGMP snooping querier.
I
Configures the transmission interval of queries.
Press I, and then the appearance of the command prompt becomes "Enter query interval
>". Enter the interval for sending queries in the range from 1 to 31,744 seconds.
F
Configures the status of high-speed secession of IGMP snooping.
Press F, and then the appearance of the command prompt becomes "Enable or Disable fast
leave(E/D)>". Press E to enable and D to disable it.
M
Configures the waiting time of the response to Query.
Press M, and then the appearance of the command prompt becomes "Enter max response
time >". Enter it in the range from 1 to 7.
R
Configures the robustness variable (or value) to use on IGMP snooping.
Press R, and then the appearance of the command prompt becomes "Enter Robustness
Value >", enter it in the range from 1 to 25 seconds.
P
Configures the proxy report.
Press P, and then the appearance of the command prompt becomes "Enable or Disable
Proxy Reporting (E/D) >", press E when enabling and D when disabling. If you press E, the
appearance of the command prompt becomes "Enter Source Address >". Then enter a
source IP of the proxy reporting.
L
Configures the upper value per 1 second of the IGMP control packets for receiving.
Press L, and then the appearance of the command prompt becomes "Enter Rate Limit (1-
1,000)". Enter it in the range from 1 to 1,000.
U
Configures the status of group learning when receiving the unknown multi cast data packets.
Press U, and then the appearance of the command prompt becomes "Enable or Disable
Unknown Data Learning(E/D)>". After that, press E when enabling and D when disabling.
D
Configures the expiration date of the unknown multi-cast data group learned.
Press D, and then the appearance of the command prompt becomes "Enter unknown data
expiry time (1-65,535)>". Enter it within the range from 1 to 65,535 seconds.
A
Configures the transmission interval of the query message(s) for transmitting when receiving a
withdrawal request.
Press A, and then the appearance of the command prompt becomes "Enter last member
query interval >". Enter it in the range from 1 to 25 seconds.
Q
Returns to the top menu.
121
Advertisement
Table of Contents
