Table of Contents
Advertisement
The following describes how to use several commands on this screen.
N
Sets a domain name.
Press N (command), and then the appearance of the command prompt becomes "Enter
RRP Domain Name". Enter the domain name to set in the range of half-size 25 characters.
T
Sets a node role.
Press T, and then the appearance of the command prompt becomes "Enter RRP Node Type
(M/T) >". Press M to set it to a master node, and T to set the type to a Transit node.
P
Sets a primary port.
Press P, and then the appearance of the command prompt becomes "Seletct port or trunk
to set (P/T)>". Select the type of a port to specify (or designate). Then the appearance of
the command prompt becomes "Enter RRP Primary Port >". Enter the port-number (from
1 to 28) to set to a primary port.
S
Sets a secondary port.
Press S, and then the appearance of the command prompt becomes "Seletct port or trunk
to set (P/T)>". Select the port type to specify. Then the appearance of the command
prompt becomes "Enter RRP Primary Port >". Enter the port-number (from 1 to 28) to set
it to the secondary port.
O
Sets the polling interval.
Press O, and then the appearance of the command prompt becomes "Enter RRP Polling
Interval>". Enter the polling-interval in the range from 1 to 2 (seconds).
F
Sets the time of time-out for polling.
Press F, and then the appearance of the command prompt becomes "Enter RRP Fail
Period>". Enter the time of time-out for the polling in the range from 2 and 5 (seconds).
C
Sets the VLAN for controlling.
Press S, and then the appearance of the command prompt becomes "Enter Control VLAN
ID >". Enter a VLAN ID (from 2 to 4,094) to set it to the VLAN for controlling. Specify the ID
with a hyphen in the case of the consecutive numbers by delimiting it with a comma and no
spaces for entering two or more port-numbers.
D
Sets the VLAN for data.
Press D, and then the appearance of the command prompt becomes "Enter Data VLAN ID
>". Enter a VLAN ID (from 1 to 4,094) to set it to the VLAN for data. Specify with a hyphen
in the case of the consecutive numbers by delimiting with a comma and no spaces for enter-
ing two or more VLAN IDs
A
Sets a domain.
,
Press A
and then the settings becomes applied.
Q
Returns to the top menu.
-------------------------------------------------------------------------------------------------------------------------------------------
Note: If you directly press Q (Quit) after setting a domain, the settings is not reflected.
Be sure to press A (Apply) to reflect the domain settings created.
-------------------------------------------------------------------------------------------------------------------------------------------
.
152
Advertisement
Table of Contents
