Table of Contents
Advertisement
O
Configures the number of retransmitting (or resending) packets for confirming the existence of
PPS.
Press O (command), and then the appearance of the command prompt becomes "Enter
maximum PPS retry count>". Enter the number of retransmitting packets which are
confirmed to exist.
P
Performs the port configuration of the PPS.
Press P (command), and then the appearance of the screen becomes "PPS Port
Configuration". This allows you to configure the port of the PPS. See 4.12.3 for the
configuration method in this situation.
G
See the PPS neighbor table.
Press G (command), and then the appearance of the screen becomes "PPS Neighbor
Table". This allows you to refer to and configure the Neighbor table of the PPS. See 4.12.4
for the configuration method in this situation.
C
See the PPS connection table.
Press C (command), and then the appearance of the screen becomes "Show PPS
Connection Table". This allows to refer to and configure the PPS connection-table. See
4.12.5 for the configuration method in this situation.
R
Set the status of the device to Stand Alone to restart the PPSP function.
Q
Returns to the top menu.
-------------------------------------------------------------------------------------------------------------------------------------------
Note: Automatically stop the PPSP function after one hour of the activation on the
Stand-alone status (or condition), and restart the PPSP function of the device (or
equipment) to make the PPS controller recognize.
-------------------------------------------------------------------------------------------------------------------------------------------
-------------------------------------------------------------------------------------------------------------------------------------------
Note: The contents, which can be managed from the PPS controller, are limited when
disabling this function is needed.
-------------------------------------------------------------------------------------------------------------------------------------------
-------------------------------------------------------------------------------------------------------------------------------------------
Note: You need to set the IP address of the transfer-destination of a virtual-link on
the layer-three (L3) switching hub, which is compatible with PPSP, when changing
the configuration to devices at multiple locations (devices exceeding the IP segment).
-------------------------------------------------------------------------------------------------------------------------------------------
163
Advertisement
Table of Contents
