Panasonic PN261693D Manual page 100

Admin/ Displays the configuration condition on an edge port (immediately movable ports
OperEdge to Forwarding). The first half (Admin: Administration) displays (or shows) config-
ured condition. The latter half (Oper: Operation) displays the actual condition.
True
False
Admin/ Displays if this device is connected as Point-to-Point.
OperPtoP The first half (Admin:Administration) displays (or shows) configured condition.
The latter half (Oper:Operation) displays the actual condition.
Auto
True
False
The following describes how to use several commands on this screen.
N Displays the next page.
Press N (command) to display the next page.
P Displays the previous page.
Press P to display the previous page.
E Configures the Edge Status on each port.
1. Press E, and then the appearance of the command prompt becomes "Select port-
number to be changed>". Enter the target port-number.
2. As the appearance of the command prompt becomes "Set point-to-point (E/D/A)>",
press E for an edge, D for disable, and A for Auto.
T Configures the P-to-P Status on each port.
1. Press T, and then the appearance of the command prompt becomes "Select port-
number to be changed>". Enter the target port-number.
2. As the appearance of the command prompt becomes "Set point-to-point (A/T/F)>",
press A for Auto, T for True, and F for False.
Q Returns to the top menu.
Configurable with an edge port
Not configurable with an edge port
Recognizes automatically depending on a port condition (Only
Admin)
P-to-P (network) is connected.
P-to-P (network) is not connected.
100