Panasonic PN261693D Manual page 98

STP Status Displays either disabled or enabled condition of a spanning tree on each port.
Enabled
Disabled
Guard Displays the enable or disable a condition of BPDU guard on each port. It is set to
"Disabled" when shipping from a factory.
Enabled
Disabled
The following describes how to use several commands on this screen.
N Displays the next page.
Press N (command) to display the next page.
P Displays the previous page.
Press P to display the previous page.
I Configures the priority of the port(s) in a switch.
1. Press I, and then the appearance of the command prompt becomes"Select port-
number to be changed>". After that, enter the target port-number.
2. As the appearance of the command prompt becomes "Enter priority for port #>",
enter the factor (or multiple) of 16; the range is from 0 to 255.
C Configures the cost of each port.
1. Press C, and then the appearance of the command prompt becomes "Select port-
number to be changed>". After that, enter the target port-number.
2. As the appearance of the command prompt becomes "Enter path cost for port #>",
enter the number; the range is from 1 to 200,000,000.
S Configures to enable or disable a spanning tree of each port.
1. Press S, and then the appearance of the command prompt becomes "Select port-
number to be changed>". After that, enter the target port-number.
2. The appearance of the command prompt becomes "Enable or Disable STP >". After
that, press E when using a spanning tree, and D when using no spanning trees.
G Configures to enable or disable the BPDU guard of each port.
1. Press G, and then the appearance of the command prompt becomes "Select port-
number to be changed>". After that, enter the target port-number.
2. The appearance of the command prompt becomes "Enable or Disable BPDU guard (E/
D)>". After that, press E when using the BPDU guard, and D when using no BPDU
guards.
Q Returns to the top menu.
A spanning tree is enabled.
A spanning tree is disabled.
BPDU guard is enabled.
BPDU guard is disabled.
98