Multicast Filtering Mode - Panasonic PN261693D Manual

4.7.4.

Multicast Filtering Mode

Press F (command) on the IGMP Snooping Configuration menu, and then you can
see Multicast Filtering Mode as Figure 4-36. You can configure a multi-cast filtering
on this screen.
PNxxxxxx Local Management System
IGMP Snooping Configuration-> Multicast Filtering Mode
VLAN
--------
1
-------------------------------- <COMMAND> -----------------------------------
[N]ext Page
[P]revious Page
Command>
Enter the character in square brackets to select option
Screen Description
VLAN
Multicast Filtering Mode
Multicast Filtering Mode
-----------------------
Forward Unregistered
Figure 4-36: Multicast Filtering Mode
Displays the waiting time: after receiving Leave packets. The factory
default settings is 5 seconds.
Displays the operation after receiving Leave packets.
Forward All of unregistered multi-cast packets cause flooding
Unregistered based on the VLAN domain. Registered multi-cast pack-
ets are transferred based on a forwarding table. If IGMP
snooping becomes enabled, the multi-cast filtering-
mode constantly operates filter-unregistered (factory
default settings).
Forward All Causes a flooding on all the multi-cast packets based on
the VLAN domain.
Filter All of unregistered multi-cast packets are filtered. Regis-
Unregistered tered packets are transferred based on the forwarding
table.
[S]et Multicast Filtering Mode
[Q]uit to previous menu
126