Panasonic PN261693D Manual page 65

Sys Cap Displays if the system capability (or function) information is included in the LLDP
frame.
Enabled
Disabled
Mgmt Addr Displays if the IP address of system(s) is included in the LLDP frame.
Enabled
Disabled
The following describes how to use several commands on this screen.
N Displays the next page.
Press N (command) to display the next page.
P Displays the previous page.
Press P to display the previous page.
S Configures to enable or disable the LLDP.
Press S, and then the appearance of the command prompt becomes "Enable or Disable (E/
D)>". After that, press E to enable and D to disable it.
L Configures the LLDP status.
1. Press L, and then the appearance of the command prompt becomes "Select port
number to be changed>". After that, enter the port-number to be changed. (Press 0
when changing all the ports , simultaneously.)
2. As the appearance of the command prompt becomes "Set Admin Status for port # (1-
4)>", press 1 for TX, 2 for RX, 3 for both of them. Press 4 to disable it.
V Configures the information to include in the LLDP frame sent from your device.
1. Press V, and then the appearance of the command prompt becomes "Select port
number to be changed>". After that, enter the port-number to be changed. (Press 0 to
change all the ports, simultaneously.)
2. As the appearance of the command prompt becomes "Enter transmit TLV", press 0 for
nothing, 1 for Port Description, 2 for System Name, 3 for System Description, 4 for Sys-
tem Capability (or function), and 5 for Management IP based on the designation-range.
E Displays a Neighbor Table.
Press E to move (or migrate) to the Neighbor Table. See next section (3.9.1) for this config-
uration.
Q Returns to the top menu.
Includes in the LLDP.
Does not include in the LLDP (factory default settings ).
Includes in the LLDP.
Does not include in the LLDP (factory default settings ).
65