Pps Configuration - Panasonic PN261693D Manual

4.12.1. PPS Configuration

PPS (Power to Progress SDN) is a function of managing two or more devices,
which configure the network with one software, and facilitates the operation and
configuration. Using this function enables to control this device from the PPS
application, which is sold separately. See the instruction manual of the PPS
application regarding the content, which can be managed from the PPS
application (sold separately).
Press F (command) on the Advanced Switch Configuration menu, and then you can
see "PPS Configuration" as Figure 4-53 below. You can configure the PPS on this
screen.
PNxxxxxx Local Management System
Advanced Switch Configuration -> PPS Configuration
PPS Global Status : Enabled
PPS Status
PPS Start Status : CPNL
Retry Count : 3
Controller ID
Controller Uptime
Controller MAC Address : xx-xx-xx-xx-xx-xx
PPS Gateway
Controller Port
Expired
-------------------------------- <COMMAND> -----------------------------------
[E]nable/Disable Global PPS
Set Controller [I]D
Set [S]tart Status
PPS [N]otification Configuration
PPS Retry C[o]unt
[Q]uit to previous menu
Command>
Enter the character in square brackets to select option
: Controlled
Timeout : 3
: xxxxxx
: 000 day(s) 05 hour(s) 41 min(s) 23 sec(s)
: xx-xx-xx-xx-xx-xx
: 10
: 68
Figure 4-53: PPS Configuration
161
PPS [P]ort Configuration
PPS Nei[g]hbor Table
PPS [C]onnection Table
[R]estart PPS
PPS [T]imeout