Panasonic PN261693D Manual page 27

The following describes how to use several commands on this screen.
S Configures to enable or disable a trap-destination.
1. Press S (command), and then the appearance of the command prompt becomes "Enter
manager entry number>. After that, enter the entry number of the trap-destination to be
configured.
2. The appearance of the command prompt becomes "Enable or Disable Trap Receiver (E/
D)>". Then press E to enable an SNMP manager, and D to disable it.
I Configures a host IP address of an SNMP manager.
1. Press I, and then the appearance of the command prompt becomes "Enter manager
entry number>. After that, enter the entry number of the trap destination to be config-
ured.
2. The appearance of the command prompt becomes "Enter IP Address for trap
receiver>". Enter an IP address for that.
D Implements the configuration of outgoing traps when changing the link-condition is needed.
Press D, and then the appearance of the screen becomes Enable/Disable Individual Trap
Menu. See section (3.2.2.) for the detailed settings.
T Configures the type of traps.
1. Press T, and then the appearance of the command prompt becomes "Enter manager
entry number>". After that, enter the entry number of the trap destination to be config-
ured.
2. The appearance of the command prompt becomes "Enter the selection>". Press 1 to set
a trap to SNMP v1, and 2 to set it to SNMP v2c.
C Configures the community name of the trap destination.
1. Press C, and then the appearance of the command prompt becomes "Enter manager
entry number>". After that, enter the entry number of the trap-destination to be
configured.
2. The appearance of the command prompt becomes "Enter community name for trap
receiver>". Enter the community name.
Q Returns to the top menu.
27