Panasonic PN261693D Manual page 25

The following describes how to use several commands on this screen.
S Configures the status of an SNMP manager.
1. Press S (command), and then the appearance of the command prompt becomes "Enter
manager entry number>". After that, enter the entry number of SNMP manager to con-
figure it.
2. The appearance of the command prompt becomes "Enable or Disable SNMP manager
(E/D)>". After that, press E to enable the SNMP manager, and D to disable it.
R Configures the access authorization of an SNMP manager.
1. Press R, and then the appearance of the command prompt becomes "Enter manager
entry number>". After that, enter the entry number of SNMP manager to configure.
2. The appearance of the command prompt becomes "Enter the selection>".
3. Press 1 if read-only works, and 2 if read-write works.
C Configures the community name of an SNMP manager.
1. Press C, and then the appearance of the command prompt becomes "Enter manager
entry number>. After that, enter the entry number of SNMP manager to configure.
2. The appearance of the command prompt becomes "Enter community name for
manager>. Then enter the name of a community.
Q Returns to the top menu.
25