Panasonic PN261693D Manual page 79

The following describes how to use several commands on this screen.
N Displays the next page.
Press N (command) to display the next page.
P Displays the previous page.
Press P to display the previous page.
V Configures the PVID.
Press V, and then the appearance of the command prompt becomes "Enter port-
number>". Enter the port-number to be configured. Press 0 when configuring all the ports.
After entering it, the appearance of the command prompt becomes "Enter Port VID for
port #>". Enter the VLAN ID to be configured in the range from 1 and 4,094.
A Adds a VLAN ID to VLANs.
Press A, and then the appearance of the command prompt becomes "Enter port-number>".
Enter the port-number to be configured. Press 0 when configuring all the ports. After
entering it, the appearance of the command prompt becomes "Seletct tagged or unagged
to set (T/U)>". Press T when configuring Tagged Only, and U when configuring Untagged.
After entering it, the appearance of the command prompt becomes "Enter VLAN ID>". Enter
a VLAN ID to add it to Hybrid VLANs.
R Deletes a VLAN ID from VLANs.
Press R, and then the appearance of the command prompt becomes "Enter port-number>".
Enter the port-number to delete the VLAN ID. Press 0 when configuring all the ports. After
entering it, the appearance of the command prompt becomes "Enter VLAN ID>". Enter the
VLAN ID to be deleted from Trunking VLANs.
F Configures a frame type.
Press F, and then the appearance of the command prompt becomes "Enter port-number>".
Enter the port-number to be configured. Press 0 when configuring all the ports. After
entering it, the appearance of the command prompt becomes "Select port acceptable
frame type (A/T/U)>". Enter a VLAN ID to add it to Hybrid VLANs. Press A for configuring
Admit All, T for Tagged Only, and U for Untagged.
G Configures the GVRP condition.
Press G, and then the appearance of the command prompt becomes "Enter port-number>".
Enter the port-number to be configured. Press 0 when configuring all the ports. After that,
the appearance of the command prompt becomes "Enable or Disable (E/D)>". Press E to
enable, and D to disable that.
Q Returns to the top menu.
79