Table of Contents
Advertisement
The following describes how to use several commands on this screen.
N
Sets a domain name.
Press N (command), and then the appearance of the command prompt becomes "Enter
RRP Domain Name". After that, enter the domain name to set in the range of half-size 25
characters.
T
Sets a node role.
Press T, and then the appearance of the command prompt becomes "Enter RRP Node Type
(M/T) >". After that, press M to set it to a master node, and T to set the type to a Transit
node.
P
Sets a primary report.
Press P, and then the appearance of the command prompt becomes "Enter RRP Primary
Port >". After that, enter the port-number (from 1 to 28) to set to the primary port.
S
Sets a secondary port.
Enter the port-number (from 1 to 28) to set it to the secondary port. Press S, and then the
appearance of the command prompt becomes "Enter RRP Secondary Port >".
O
Sets the polling interval.
Press O, and then the appearance of the command prompt becomes "Enter RRP Polling
Interval>". After that, enter the polling interval in the range from 1 to 2 (seconds).
F
Sets the time of time-out for polling.
Press F, and then the appearance of the command prompt becomes "Enter RRP Fail
Period>". Enter the time of time-out for the polling in the range from 2 to 5 (seconds).
C
Sets the VLAN for controlling.
Press S, and then the appearance of the command prompt becomes "Enter Control VLAN
ID >". Enter the VLAN ID (from 2 to 4,094) to set to the VLAN for controlling. Specify with
a hyphen in the case of the consecutive numbers by delimiting it with a comma and no
spaces when entering two or more port-numbers.
D
Sets the VLAN for data.
Press D, and then the appearance of the command prompt becomes "Enter Data VLAN ID
>". Enter the VLAN ID (from 1 to 4,094) to set to the VLAN for data. Specify with a hyphen
in the case of the consecutive numbers by delimiting with a comma and no spaces when
entering two or more VLAN IDs.
A
Sets a domain.
Press A, and then the setting is applied.
Q
Returns to the top menu.
-------------------------------------------------------------------------------------------------------------------------------------------
Note: If you press Q directly after setting a domain, the settings is not reflected. Be
sure to press A (Apply) to reflect the domain settings modified.
-------------------------------------------------------------------------------------------------------------------------------------------
154
Advertisement
Table of Contents
