Panasonic PN261693D Manual page 38

The following describes how to use several commands on this screen.
C Configures time needed to disconnect automatically if nothing is entered when a console is con-
nected.
Press C (command), and then the appearance of the command prompt becomes "Enter
console idle timeout>". Configure the (numerical) value between 0 and 60 (minutes). If 0 is
configured, automatic disconnection is not operated.
T When nothing is entered with becoming connected by Telnet, the time (needed) until a discon-
nection occurs automatically is configured.
Press T, and then the appearance of the command prompt becomes "Enter telnet idle
timeout>". After that, configure the (numerical) value in the range from 1 to 1,439
(minutes).
L Configures if Telnet enables access.
Press L and then the appearance of the command prompt becomes "Enable or Disable
telnet server(E/D)>". After that, press E to enable the access, and D to disable (or discon-
nect) it.
W Configures if the function of WEB authentication is enabled. Enable the function of WEB
authentication from CLI to change it to Enable automatically.
Press W and then the appearance of the command prompt becomes "Enable or Disable
web server (E/D)>". After that, press E to enable the access, and D to disable it.
B Configures LED base mode.
Press B to move to LED Basic Mode Configuration. See next section (3.5.5) for this configu-
ration.
R Perform the access configuration of RADIUS server to use for IEEE802.1X authentication.
Press R to move to RADIUS Configuration Page. See next section (3.5.2) for this configura-
tion.
Y Configures if the system log is transmitted to a Sys-log server.
Press Y and then the appearance of the command prompt becomes "Enable or Disable
Syslog Transmission (E/D)>". After that, press E to configure for transmitting a system log
to Sys-log server, and D otherwise.
S Configures if an access using SNMP needs to be possible.
Press S, and then the appearance of the command prompt becomes "Enable or Disable
SNMP Agent(E/D)>". After that, press E to enable the access, and D to disable it.
I Configures if the access to ZEQUO assist and software of IP address configuration needs to
possible.
Press I, and then the appearance of the command prompt becomes
setup interface (E/D)>". After that, press E to enable the access, and D to disable it.
A Configures the accessible terminal on Telnet.
Press A to move to Telnet Access Limitation Menu
ration.
G Configures the condition of transmitting the system log to Syslog server.
Press G to move to Syslog Transmission Configuration Page. See next section (3.5.3) for this
configuration.
H Configures an SSH server.
Press H to move to SSH Server Configuration. See next section (3.5.4) for this configuration.
.
See next section (3.5.1) for this configu-
38
"
Enable or Disable IP