Panasonic PN261693D Manual page 60

The following describes how to use several commands on this screen.
S Configures the SNTP status.
Press S (command), and then the appearance of the command prompt becomes "Enable or
Disable (E/D)>". After that, press E to enable and D to disable it.
I Configures the interval of time synchronization with SNTP servers.
Press I (command), and then the appearance of the command prompt becomes "Enter
Interval Time>". After that, configure the time needed in the range from 30 to 99,999 (sec-
onds).
4 Configures an IPv4 address of an SNTP server.
Press 4 (command), and then the appearance of the command prompt becomes "Enter new
IP address>". After that, enter the IPv4 address of the SNTP server.
6 Configures an IPv6 address of an SNTP server.
Press 6 (command), and then the appearance of the command prompt becomes "Enter new
IPv6 address>". After that, enter the IPv6 address of the SNTP server.
D Deletes the IPv4 address registered.
Press 4 (command), and then the appearance of the command prompt becomes "Enter IP
address>". After that, enter the IPv4 address to be deleted.
P Deletes the IPv6 address registered.
Press 6 (command), and then the appearance of the command prompt becomes "Enter IPv6
address>". After that, enter the IPv6 address to be deleted.
Q Returns to the top menu.
60