Operator Intervention Messages
22 June 2004
Table 7-2 describes some of the operator intervention
messages. Each intervention message is composed of four
lines. The third and/or fourth lines may contain variable
information specific to the message. For SAC indications, refer
to Service Action Codes on page 7-3. For Code error modifiers,
refer to the Scalar 1000 Maintenance Guide.
Table 7-2
Operator Intervention Messages
Message Lines
Alert not found.
Press Enter.
WARNING!
The accessor could
not be parked.
[OK]
WARNING!
Moving tapes may
corrupt partitions.
Continue: %X
-=>ERROR!<=-
Initialization Error
Code: 0x%X
-=>PERM ERROR!<=-
CALL FOR SERVICE
SAC :%X
Code:0x%Y
-=>PERM ERROR!<=-
SYSTEM WILL REBOOT
SAC :%X
Code:0x%Y
->SYSTEM REBOOTED<-
NEW CODE LOADED
Version %XXXX.%YYYYY
->SYSTEM REBOOTED<-
RECOVERED FROM ERROR
SAC :%X
Code:0x%Y
Variables
None
None
%X = Y to continue
%X = 8 digits hex
error modifier
%X = 2 digit hex
%Y = 8 digit hex
error modifier
%X = 2 digit hex
%Y = 8 digit hex
error modifier
current version
%X = 4 digit major rev
%Y = 5 digit minor rev
%X = 2 digit hex
%Y = 8 digit hex
error modifier
Operator Intervention Messages
7-23