22 June 2004
DI/DO Submenu
Path: Main Menu Service Menu Diags
Submenu DI/DO Submenu
Use the (Digital Input/Digital Output) DI/DO Submenu to
perform system tests. See Figure 5-161.
> Loopback
Sensors
Locks
...
Figure 5-161
Depending on your selection, you have the following options:
•
Loopback Dialog
•
Sensors Submenu on page 5-118
•
Locks Dialog on page 5-121
Loopback Dialog
Path: Main Menu Service Menu Diags
Submenu DI/DO Submenu
Use the Loopback Dialog to send test signals from the
main control card to other system cards and return.
See Figure 5-162.
Device: LMC
Number: 01
Results:
Figure 5-162
Parameter
Device
Number
...
DI/DO Submenu
Loopback Dialog
Accept: N
Loopback Dialog
Value
Indicates the loopback tests to
run (LMC, LGR, LPN).
Indicates which device
number should be tested. This
field is always set to 01 because
there is only one of each device
to be tested in the Scalar 1000.
Service Menu 5-117