Configuring Network Parameters - Quantum Scalar 1000 Operator's Manual

Configuring Network Parameters

22 June 2004
• Library Status - Indicates whether the library is
online or offline.
• Drive Status - Indicates the type and quantity
of tape drives in the library.
• RMU User - Indicates the user name and IP
address of the current user.
• Hostname - Indicates the hostname of the
RMU.
• IP Address - Indicates the IP address for the
RMU connection.
• MAC Address - Indicates the Media Access
Control (MAC) address of the RMU. This is also
the serial number of the RMU.
• Library Serial # - Indicates the library serial
number.
• SNMP - Indicates whether SNMP requests and
alerts are enabled or disabled.
• SNMP Alerts - Indicates whether the SNMP
Alert notification feature is enabled or disabled.
• Library Firmware - Indicates the current level
of library firmware.
• RMU Firmware - Indicates the current level of
RMU firmware.
You can reconfigure the hostname, IP address, subnet
mask, and gateway address through the RMU. This feature
requires you to log in to the RMU. See Logging into the RMU
on page 4-14 for more information.
To configure the network parameters
Step 1 Click the Configuration tab.
Step 2 In the Network Configuration area, enter the new
hostname, IP address, subnet mask, and gateway
address.
Step 3 Click Submit and review your changes (indicated
in red).
Enter your password and click Confirm to
Step 4
complete the procedure.
The new values are saved. Note that you may need
to redirect your Web browser if you are logged out.
Using the Remote Management Unit 4-15