Configuring Snmp - Quantum Scalar 1000 Operator's Manual

Configuring SNMP

4-16 Operation
Simple Network Management Protocol (SNMP) is a set of
protocols used to manage nodes on an IP network. You can
configure the RMU to send alerts to and respond to requests
from an SNMP management application.
To configure SNMP
Step 1 Click the Configuration tab.
In the SNMP Configuration area, do the following:
Step 2
• To enable or disable the feature, select ON or
OFF in the SNMP Enabled drop-down.
• To enable or disable SNMP alerts, select ON or
OFF in the Alerts Enabled drop-down. SNMP
must be enabled if you want SNMP alerts
enabled.
• In Manager, enter the SNMP server address.
• In Public Name, enter the name of the read-
only SNMP community.
• In Private Name, enter the name of the
read/write SNMP community.
Step 3 Click Submit and review your changes (indicated
in red).
Step 4 Enter your password and click Confirm to
complete the procedure.
The new values are saved. Note that you may need
to redirect your Web browser if you are logged out.
Step 5 Click Done.
You may be instructed to reboot the RMU.
6-00054-02 Rev A