Shutting Down The Scalar 1000; Normal Shutdown; Figure 4-4 Reboot Message - Quantum Scalar 1000 Operator's Manual

Shutting Down the Scalar 1000

Attention
Figure 4-4
22 June 2004
You can shutdown the Scalar 1000 using the normal
shutdown procedure (recommended for most situations) or
the emergency shutdown procedure.
Except in emergency situations, shutdown the Scalar 1000
using the normal shutdown and not the emergency
shutdown procedure.

Normal Shutdown

Use the following shutdown procedure to shutdown the
Scalar 1000.
If an RMU is installed in the library, wait at least one minute
between powering down the library and powering up the
library. This allows the RMU to properly reset.
Step 1
Step 2
Step 3
Step 4
The library may now
Reboot Message
Step 5
If necessary, use the
Main Menu. The selector defaults to the Mode
selection.
Press the button.
From the Mode screen, use the
the Shutdown mode.
Press the button.
The cursor moves to Shutdown mode and the state
automatically changes to Shutdown. The Accessor
completes the current task, returns to the home position,
and the reboot message appears. See Figure 4-4.
be rebooted.
Locate the Main Circuit Breaker switch in the lower
right corner at the back of the CM.
See Figure 4-2 on page 4-7 for the location of the
Main Circuit Breaker switch.

Shutting Down the Scalar 1000

button to return to the
button to select
4-9