Enabling Library AutoClean
22 June 2004
The host should not share Scalar 1000 controlled cleaning
media. If a host uses the Scalar 1000 firmware controlled
cleaning media, the Scalar 1000 firmware will not update
cleaning media usage information.
Use this procedure to set autoclean. For further information,
refer to Drives Dialog on page 5-93.
Path: Setup Menu Cleaning Submenu
Step 1
Follow the path and the Cleaning Submenu
appears. See Figure 6-3.
>Drives
...
...
Media
...
View
Figure 6-3
Cleaning Submenu
Step 2
Select Drives and the AutoClean dialog appears.
See Figure 6-4.
AutoClean:
Schedule: Delayed
Hours: 00Min :00
Accept:: N
Figure 6-4
AutoClean Dialog
Select AutoClean, set the schedule (immediate or
Step 3
delayed), Hours, Min (time to start the cleaning),
Accept.
Immediate - every dismount causes the firmware to
check for a cleaning request from the drive. If the
firmware receives a clean drive request, the drive is
cleaned immediately, and the tape move complete
response is delayed until the cleaning process is
complete.
Y<
Enabling Library AutoClean
6-23