Advertisement
Quick Links
Preparing to Replace a Hard Drive Blank
Table 1 Scalar LTFS Appliance
Hard Drive Blank Kit
© 2013 Quantum Corporation. All rights reserved. Quantum, the Quantum logo, DLT, DLTtape, the DLTtape logo, SuperLoader,
Scalar, DXi, StorageCare, StorNext, GoProtect, and Vision are registered trademarks of Quantum Corporation and its affiliates
in the United States and/or other countries. All other trademarks are the property of their respective owners. Quantum
specifications are subject to change.
6-68094-01 Rev A, December 2013
Hard Drive Blank Replacement
To replace the hard drive blank in the Scalar
Appliance, refer to the following sections:
•
Preparing to Replace a Hard Drive Blank
•
Removing a Hard Drive Blank
•
Removing a Hard Drive Blank
Before beginning the replacement procedure, make sure that you have the
required replacement kit. Refer to the following table for the replacement kit
contents (see
Table 1
on page 1).
Qty
Illustration
1
Quantum Scalar LTFS
®
Linear Tape File System (LTFS)
on page 1
on page 2
on page 2
*6-68094-01 A*
Appliance:
Description
Replacement hard
drive blank
Advertisement
Related Manuals for Quantum Scalar LTFS
Summary of Contents for Quantum Scalar LTFS
- Page 1 © 2013 Quantum Corporation. All rights reserved. Quantum, the Quantum logo, DLT, DLTtape, the DLTtape logo, SuperLoader, Scalar, DXi, StorageCare, StorNext, GoProtect, and Vision are registered trademarks of Quantum Corporation and its affiliates in the United States and/or other countries. All other trademarks are the property of their respective owners. Quantum specifications are subject to change.
-
Page 2: Removing A Hard Drive Blank
Quantum Scalar LTFS Appliance: Hard Drive Blanks Replacement 6-68094-01 Rev A December 2013 Required Tools: None. Removing a Hard Drive Blank Caution: To prevent overheating, do not leave a slot open for more than 5 minutes. To remove a hard drive blank, complete the following steps:... - Page 3 Quantum Scalar LTFS Appliance: Hard Drive Blanks Replacement 6-68094-01 Rev A December 2013 Figure 3 shows the Front of the Scalar LTFS after the bezel is removed. Figure 2 Front of the Scalar LTFS System Software Empty Drive Bays 2 Identify the blank you want to release and press the release tab (see Figure 3 Slide the blank out until it is free of the drive bay.
- Page 4 3 If you removed the front bezel, place it back on the chassis: a Hook the right end of the bezel onto the chassis of the top Scalar LTFS Appliance. b Fit the free end of the bezel onto the chassis.