Restarting The Scalar 1000; Using The Remote Management Unit - Quantum Scalar 1000 Operator's Manual

Restarting the Scalar 1000

Using the Remote Management Unit

22 June 2004
Use the following procedure to restart the Scalar 1000.
Power up must be delayed by one minute after a power
down condition to allow the RMU to properly reset.
Step 1 If applicable, correct any situations that required
the Scalar 1000 shutdown.
Step 2 Refer to Starting the Scalar 1000 on page 4-7 for
instructions on the Scalar 1000 start procedure.
The Remote Management Unit (RMU) is a component in the
library that provides remote access to the library by means of
a Web browser. All functions listed here are available without
the need of a dedicated server (or separate software).
The RMU performs the following functions:
• Provides remote operation of all library Operator Panel
functions by means of a Web browser.
• Allows you to check the status of the system, firmware
levels, and other useful information.
• Updates RMU firmware.
• Supports Simple Network Management Protocol (SNMP)
version 2.0 and acts as an SNMP-server, generating SNMP
traps and responding to SNMP requests.
• Supports ADIC Library Management Information Base
(MIB) version 2.0.
• Acquires Tape Alert 3.0 information from the library and
sends that information to an SNMP manager.
• Detects a power loss and generates an SNMP trap for
notification.
• Enables the retrieval of library logs, and drive and RMU
diagnostic files.
• Allows RMU configuration changes such as network,
users, and date/time.
• Provides online access to documentation.

Restarting the Scalar 1000

4-11