Quantum Scalar 1000 Operator's Manual page 272

Table 7-1
Reported
SAC
D0 The Library detected that one of the DC Power supplies has failed. This error
condition only occurs in Libraries equipped with the Redundant DC Power
Supplies Feature.
Action 1
Contact ATAC. For contact information, refer to ADIC Technical Assistance
Center on page 1-5.
D1 The Library detected that AC input to one bank of the DC Power supplies is
missing. This error condition only occurs in Libraries equipped with the
Redundant DC Power Supplies Feature.
Action 1
Contact ATAC. For contact information, refer to ADIC Technical Assistance
Center on page 1-5.
F0 Failures were detected while running the diagnostic loop test from the LSC
card to the LMC card.
Action 1
Contact ATAC. For contact information, refer to ADIC Technical Assistance
Center on page 1-5.
F1 Failures were detected while running the diagnostic loop test from the LSC
card to the LPN1 card.
Action 1
Contact ATAC. For contact information, refer to ADIC Technical Assistance
Center on page 1-5.
F2 Failures were detected while running the diagnostic loop test from the LSC
card to the LGR card.
Action 1
Contact ATAC. For contact information, refer to ADIC Technical Assistance
Center on page 1-5.
F3 Failures were detected while running the diagnostic loop test from the LSC
card to all sensors on the Gripper Assembly.
Action 1
Contact ATAC. For contact information, refer to ADIC Technical Assistance
Center on page 1-5.
7-20 Error Messages
SAC Reporting (Continued)
Perform these actions
6-00054-02 Rev A