Turning Off the Scalar LTFS Appliance
© 2013 Quantum Corporation. All rights reserved. Quantum, the Quantum logo, DLT, DLTtape, the DLTtape logo, SuperLoader,
Scalar, DXi, StorageCare, StorNext, GoProtect, and Vision are registered trademarks of Quantum Corporation and its affiliates
in the United States and/or other countries. All other trademarks are the property of their respective owners. Quantum
specifications are subject to change.
6-68096-01 Rev A, December 2013
To replace the rails in your Scalar Linear Tape File System (LTFS) Appliance, refer
to the following sections:
•
Turning Off the Scalar LTFS Appliance
•
Preparing To Remove the Scalar LTFS Appliance
•
Removing the Chassis and Rails From the Rack
•
Replacing the Rails in the Rack
•
Reinstalling the Chassis in the Rack
•
Turning On the Scalar LTFS Appliance
Follow these steps to cleanly shut down and power off the Scalar LTFS Scalar
LTFS Appliance:
1 Open an ssh connection to the Scalar LTFS Appliance, and log in as the
service user:
• User: service
• Password: The customer-supplied password.
2 Enter sudo rootsh.
3 Enter the password for the service user account a second time.
4 Enter /sbin/poweroff.
Both the operating system and the system software are gracefully shut
down, and then the system powers off.
Quantum Scalar LTFS
Rail Replacement
on page 1
on page 3
on page 5
on page 7
*6-68096-01 A*
Appliance:
on page 2
on page 2