Security Dialog; Switching Security From Off To On - Quantum Scalar 1000 Operator's Manual

22 June 2004

Security Dialog

Path: Main Menu Setup Menu Library
Submenu Security Dialog
Use the Security Dialog to change the Operator Panel
LCD Security mode or the password that protects it. The
Operator Panel can also be secured by the host. Whichever
method is used to secure the Operator Panel, it must be the
method used to release the security. See Figure 5-106.
Security Enabled: N<
Change password : N
Figure 5-106

Switching Security From Off to On

Parameter
Security Enabled
Change password Y if the password is to be
Accept
Accept : N

Security Dialog

Value
Y to enable LCD security
(N indicates that LCD security
is not enabled.)
changed, refer to Changing the
Password on page 5-82.
N if the password is not to be
changed.
If no password has been set
since the library was rebooted,
the operator will be forced to
change the password. Refer
to Changing the Password on
page 5-82.
Y to accept changes
N to reject changes
Setup Menu 5-79