Quantum Scalar 1000 Operator's Manual page 270
Quantum scalar 1000: user guide
Hide thumbs
Also See for Scalar 1000:
- Reference manual (304 pages) ,
- Release note (4 pages) ,
- Warranty (6 pages)
Table of Contents
Advertisement
Table 7-1
Reported
SAC
85
X-Axis failed to reach target.
Action 1
Contact ATAC. For contact information, refer to ADIC Technical Assistance
Center on page 1-5.
86
The first full speed move command issued when the Accessor is at home
position failed.
Action 1
Contact ATAC. For contact information, refer to ADIC Technical Assistance
Center on page 1-5.
87
The Accessor cannot move away from the X-Axis home position.
Action 1
Contact ATAC. For contact information, refer to ADIC Technical Assistance
Center on page 1-5.
88
The Accessor cannot move away from the Y-Axis home position.
Action 1
Contact ATAC. For contact information, refer to ADIC Technical Assistance
Center on page 1-5.
90
An LSC1 card was detected by the Library firmware when an LSC2 card is
required for this Library configuration to operate.
Action 1
Contact ATAC. For contact information, refer to ADIC Technical Assistance
Center on page 1-5.
91
An LMC1 card was detected by the Library firmware when an LMC3 card is
required for this Library configuration to operate.
Action 1
Contact ATAC. For contact information, refer to ADIC Technical Assistance
Center on page 1-5.
92
An LBI1 card was detected by the Library firmware when an LBI2 card is
required for this Library configuration to operate.
Action 1
Contact ATAC. For contact information, refer to ADIC Technical Assistance
Center on page 1-5.
7-18
Error Messages
SAC Reporting (Continued)
Perform these actions
6-00054-02 Rev A
Advertisement
Table of Contents
