Note
The Scalar 1000
defaults to SCSI
ID 6.
5-74
Menus and Commands
Target ID Dialog
Path: Main Menu Setup Menu Library
Submenu SCSI Submenu
Use the Target ID Dialog to set the library SCSI ID.
Changes will not take effect until library power is cycled.
See Figure 5-101.
Target ID:
Next
Bus 0:
Bus 1:
Accept: N
Figure 5-101
Target ID Dialog
Parameter
Bus 0: Next
Bus 0: Now
Bus 1: Next
Bus 1: Now
Accept
If Y is selected for the Accept parameter value, the screen
updates to reflect the changes. Otherwise, the changed
parameters continue to display but no action is taken.
Target ID Dialog
Now
4<
4
4
4
Value
Next indicates the SCSI ID
address that takes effect for
bus port 0 after power is cycled
(0–7).
Now indicates the SCSI ID
address that is currently in
effect (0–7) for bus port 0.
Next indicates the SCSI ID
address that takes effect for
bus port 1 after power is cycled
(0–7).
Now indicates the SCSI ID
address that is currently in
effect (0–7) for bus port 1.
Y to accept changes
N to reject changes
6-00054-02 Rev A