Drives Dialog - Quantum Scalar 1000 Operator's Manual

Drives Dialog

Note
Drive ID
Override does
not work on LTO
drives..
22 June 2004
Path: Main Menu Setup Menu Drives Dialog
Use the Drives Dialog to modify the SCSI ID for all drive
models except TD3610, 3590-B1A, 3590-E1A, Ultrium-TD1
(LTO-1), and Ultrium-TD2 (LTO-2).
See Figure 5-120.
Drive ID Override:
Enabled <
Set Drive ID:
Figure 5-120

Drives Dialog

Parameter
Drive ID Override Enabled allows the operator to
Set Drive ID
Accept
If Enabled is selected or was previously selected for the
Drive ID Override parameter and Y is selected for the Set
Drive Id and the Accept parameters, the SCSI ID Dialog
appears. Refer to Figure 5-121 on page 5-92.
If Drive ID Override is disabled and Y is selected for
Accept, the changed parameters continue to display but
no new screen action is displayed.
If N is selected for the Accept parameter, the changed
parameters continue to display but no action is taken.
N
Accept: N
Value
enable the setting of SCSI ID
for supported drives
Disabled prevents the library
from setting the SCSI ID for
supported drives
Y to view and set the drive
SCSI ID
N to not change the drive SCSI
ID
Y to accept changes
N to reject changes
— or —
Setup Menu 5-91