Quantum Scalar 1000 Operator's Manual page 262

Table 7-1
Reported
SAC
34 A general SCSI failure is detected.
Action 1
Contact ATAC. For contact information, refer to ADIC Technical Assistance
Center on page 1-5.
35 A fatal SCSI error is detected but the Port is unknown.
Action 1
Contact ATAC. For contact information, refer to ADIC Technical Assistance
Center on page 1-5.
39 An Ethernet Network error was detected by the Remote Management Unit
(RMU).
Action 1
Make sure the Ethernet cable is properly connected to the RMU and that you
have a valid link and activity LEDs illuminated on the Ethernet port.
Action 2
Verify that the network the RMU is connected to is working properly.
Action 3
If the problem is not corrected or persists, contact ATAC. For contact
information, refer to ADIC Technical Assistance Center on page 1-5.
40 The Library Aisle power cannot be enabled.
Action 1
Check that all front doors are closed and properly locked.
Action 2
If the problem is not corrected or persists, contact ATAC. For contact
information, refer to ADIC Technical Assistance Center on page 1-5.
41 The Library Aisle power cannot be disabled, failures are detected in the
Digital In/Digital Out (DI/DO) circuitries.
Action 1
Contact ATAC. For contact information, refer to ADIC Technical Assistance
Center on page 1-5.
42 A wrong library configuration is detected, the data reporting the number of
frames (modules) installed is different than expected.
Action 1
Contact ATAC. For contact information, refer to ADIC Technical Assistance
Center on page 1-5.
7-10 Error Messages
SAC Reporting (Continued)
Perform these actions
6-00054-02 Rev A