Lamp Compartment; Anode Yoke - Christie D4K35 Service Manual

1. Remove the rear right skin. Refer to
Rear Right Skin (ignitor/blower
compartment).
2. Loosen the thumbscrew. (Figure 5-48)
3. Disconnect the five DC harnesses via the
inline connectors.
4. Disconnect the AC harness via the inline
connectors.
5. Slide the LVPS out along the bracket.

5.12 Lamp Compartment

5.12.1 Anode Yoke

The anode yoke is located directly in front of the reflector and its position is adjustable depending on the lamp
being installed.
(Estimated Replacement Time: 4 minutes)
1. Open the lamp door. Refer to
2. Remove the lamp (if installed). Refer to
3. Using a 5mm hex key, remove the two screws and lock washers from the yoke base. (Figure 5-49)
D4K35 Service Manual
020-100817-01 Rev. 1 (04-2012)
5.4.4
5.4.8 Lamp Door.
5.12.5 Lamp
Figure 5-49 Front of Lamp Compartment
Section 5: Parts and Module Replacement
Figure 5-48 Thumbscrew
Replacement.
5-31