Profile Settings - Partex ProMark MK9 Quick Start Manual

PROFILE SETTINGS

Art. No PVC Material
PO-02000SN*
PO-03000SN*
PO-04000SN*
PO-05000SN*
PO-06000SN*
PO-07000SN*
PP-04600SN*
PP-09000SN*
Art. No PVC Material
PO-068TW0SN*
In AUTO maximum character size is automatically selected by the MK9 with respect to
selected tube diameter and pitch length. If a shorter pitch length is needed due to e.g space
reasons in a control panel a smaller character size selection can be the result of the printout.
The settings given above are base on standard settings of space between characters and
character width. By selecting smaller values on these settings more characters with a larger
font can be printed on a given pitch length but with gradually less readability!
A.
Feed the profile trough the
machine so that it prints on the
side that faces the reel core
(See the example to the right)
B.
Feed the profile trough the
machine so that it prints on the
side that doesn't face the reel
core.
(See the example to the right)
Hints
:
* To get a good printing result the profiles temperature should be at least +25°C
* When you are feeding the machine with profile, make sure that the profile side that faces
the reel core is turned upwards before you close the cassette cover.
* To get a good printing result on Zerex profile, change the machines density value
Quick Start
Profile on Compactadiscs
Art. No Zerex Material
POZ02000KN*
POZ03000KN*
POZ04000KN*
POZ05000KN*
POZ06000KN*
POZ07000KN*
Art. No Zerex Material
Doc:
Sidan/ Page:
Chr.size mm in
Tube diam.
MANUAL
Selected (mm)
selectable
2,5 2,0
2,5 2,0
3,2 2,0
3,6 3,0
3,6 3,0
4,2 (5,2) 3,0
2,5 2,0
5,2 3,0
Chr.size mm in
TAPE. Selected
MANUAL
(mm)
selectable
9,0 4,0
MK9-M-04-02
31
See instruction
A
A
A
A
A
A
A
A
See instruction
B