If A Tube Or Label Tape Becomes Jammed; Action To Take Against Media Jam (When The "Media Jam" Message Is Displayed) - Partex PROMARK T-800 User Manual

5.1 If a Tube or Label Tape Becomes Jammed

If a tube or tape is jammed during printing, a "Media JAM" message is displayed on the LCD and the printer stops.
Remove the jammed tube or tape according to the messages shown on the display.
If you cannot do this because the "Media JAM" message is not shown although a tube or tape is jammed or you have
turned off the printer after display of the "Media JAM" message, use the feed function of the printer to remove the
jammed printing media.
"Actions to Take against Other Jams (When the "Media JAM" message is not displayed)" (

Action to Take against Media Jam (When the "Media JAM" message is displayed)

When the printer stops printing due to a jammed tube or tape and consequently the "Media JAM" message is display-
ed, remove the jammed tube or tape following the procedure mentioned below.
1
Make sure that the "Media JAM" message is di-
splayed on the LCD.
If the "Media JAM" message is not displayed or it has disap-
peared because you have turned off the printer, take an ap-
propriate action according to "Actions to Take against Other
Jams (When the "Media JAM" message is not displayed)"
( page 126).
If you select "Cancel", the "Media JAM" message disappears
and the input display is displayed again, causing you to exit from
the jam clearing procedure. In this case, refer to "Actions to Take
against Other Jams (When the "Media JAM" message is not di-
splayed)" (
2
Press the [Enter] key.
The Feed display appears.
3
Open the cover.
4
Remove the ribbon cassette from the printer.
If the ribbon winds itself around some parts inside the printer and
therefore the ribbon cassette cannot be removed, proceed to
step 5 without removing it.
124
page 126).
page 126).