Revert To The Default Factory Configuration On An Ex Series Switch - Juniper EX4100 Hardware Manual

Revert to the Default Factory Configuration on an EX Series Switch

IN THIS SECTION
Revert to the EX Series Switch Factory-Default Configuration Using the
Command | 176
Revert to the EX Series Switch Factory-Default Configuration Using the
Command | 176
Revert to the Factory-Default Configuration Using the Factory Reset/Port Mode button | 177
With EX Series switches, if for any reason the current active configuration fails, you can revert to the
factory-default configuration.
You can also roll back to a previous configuration, as described in
Changes, or revert to the rescue configuration, as described in
the EX Series Switch.
TIP: If you have lost the root password, it is not necessary to revert to the factory-default
configuration to reset it. See
The factory-default configuration contains the basic configuration settings for the switch. This is the first
configuration of the switch and is loaded when the switch is first powered on. For the factory-default
configuration file for your switch, see the hardware documentation for your switch.
TIP: On fixed-configuration switches, you can run the EZsetup script to complete the initial
after reverting to the factory-default configuration. (The EZsetup script is not
configuration
available on modular switches. To configure modular switches, use the CLI or the J-Web
interface.) For information about completing the initial configuration using either the CLI or the
Connecting and Configuring an EX Series Switch (CLI Procedure)
J-Web interface, see
Connecting and Configuring an EX Series Switch (J-Web Procedure)
You can revert to the factory-default configuration by using the request system zeroize operational
command or the load factory-default configuration command to revert to the factory-default
configuration file that contains all default settings
These procedures are described in the following sections:
Recovering the Root Password on
except the root password setting, which is retained.
request system zeroize
load factory-default
Rolling Back Junos OS Configuration
Reverting to the Rescue Configuration for
Switches.
.
175
or