Wall-Mounting Warnings For Ex2200 Switches; Grounded Equipment Warning; Ex Series Switches, The Ex Series Redundant Power System (Rps), And The Xre200; External Routing Engine - Juniper EX2200 Hardware Manual

Wall-Mounting Warnings for EX2200 Switches

Related
Documentation

Grounded Equipment Warning

Copyright © 2016, Juniper Networks, Inc.
WARNING:
When mounting an EX2200 switch chassis in a vertical position, orient the
front panel of the chassis downward to ensure proper airflow and meet
safety requirements in the event of a fire.
When wall mounting Power over Ethernet (PoE) models (EX2200-24P
and EX2200-48P), install the wall-mount baffle above the units to reduce
the risk of objects or substances falling into the air exhaust or power supply,
which could cause a fire.
Mounting an EX2200 Switch on a Wall on page 128
This topic applies to hardware devices in the EX Series product family, which includes

EX Series switches, the EX Series Redundant Power System (RPS), and the XRE200

External Routing Engine.

This topic also applies to hardware devices in the QFX Series, to OCX1100 switches, and
to NFX250 devices.
WARNING: The device is intended to be grounded. During normal use, ensure
that you have connected earth ground to the chassis.
Waarschuwing Deze apparatuur hoort geaard te worden Zorg dat de
host-computer tijdens normaal gebruik met aarde is verbonden.
Varoitus Tämä laitteisto on tarkoitettu maadoitettavaksi. Varmista, että
isäntälaite on yhdistetty maahan normaalikäytön aikana.
Attention Cet équipement doit être relié à la terre. S'assurer que l'appareil
hôte est relié à la terre lors de l'utilisation normale.
Warnung Dieses Gerät muß geerdet werden. Stellen Sie sicher, daß das
Host-Gerät während des normalen Betriebs an Erde gelegt ist.
Avvertenza Questa apparecchiatura deve essere collegata a massa. Accertarsi
che il dispositivo host sia collegato alla massa di terra durante il normale
utilizzo.
Advarsel Dette utstyret skal jordes. Forviss deg om vertsterminalen er jordet
ved normalt bruk.
Chapter 21: Installation Safety Guidelines and Warnings
229