Checking Vtr/Disk Recorder/Extended Vtr Information - Sony MVS-8000X User Manual

To stop recording
Press the [STOP] button or the [ALL STOP] button in the device control block.
Checking VTR/Disk Recorder/Extended VTR
Information
You can check the VTR/disk recorder/Extended VTR information (timecode
information and operating status) set in the device control block, in the Device
menu display.
To check the VTR/disk recorder/Extended VTR information, press VF3 'VTR'
and HF1 'Cueup & Play' or HF2 'Timeline' in the Device menu.
The Device >DDR/VTR >Cueup & Play menu or Device >DDR/VTR
>Timeline menu appears, and a list shows the timecode information and
operating status for each device. The columns of the list show the following
information.
DEV (device name): DEV1 to DEV12 represent respectively device 1 to
device 12.
Reg (register): Number of the register to which settings apply.
Status: Status of each device. The meaning of the indications is as follows.
Operating
status display
XXXX
Local
Tape Out
Rec
Cue>
Cue<
Eject
Stb Off
Stop
Play
When VTR, Extended VTR, or
Sony disk 9-pin protocol is
used
Communications with the
device are being carried out
normally, but status information
is not received.
The REMOTE/LOCAL switch
of the device is set to LOCAL.
No tape is loaded (VTR).
No file loaded. (Sony disk 9-pin
protocol or Extended VTR)
Recording.
Cueing up in the forward
direction.
Cueing up in the reverse
direction.
Ejecting cassette.
Stopped in standby off mode.
Stopped in standby on mode.
Playing.
Control of VTRs, Extended VTRs, and Disk Recorders
When video disk
communications protocol is
used
Not communicating, or
communicating but the device
type cannot be read.
Port is not open.
No file loaded.
Recording.
—
—
—
—
Stopped.
Playing.
205