Wipe Crop Settings - Sony XVS Series User Manual

1
In the DME >Edge >Flex Shadow menu (4115), press
[Flex Shadow], turning it on.
2
In the <Flex Shadow Source> group, select [External].
3
Select [Axis Loc] and set the [Axis Loc V] parameter
so that the center of the flex shadow deformation is at
the bottom of the picture.
(In 16:9 mode: Axis Loc V = –9.00)
It is recommended that the operation is performed by
displaying the flex shadow center axis by enabling
[Flex Shadow Axis] in the DME >Input/Output
>Graphic menu (4164).
4
In the <Invert> group, select [V] to invert the flex
shadow vertically.
5
Select [Size] and set the [Size V] parameter so that the
shadow extends vertically.
(In 16:9 mode: Size V = –1.50)
6
Select [Skew] and set the [Skew H] parameter so that
the parallel lines appear to emerge from the rear at the
right.
(In 16:9 mode: Skew H = –50.00)

Wipe Crop Settings

Notes
• Enabling wipe crop disables any mask that is set.
• When brick is set, wipe crop cannot be enabled. Brick
must be disabled in order to enable wipe crop.
• When [Output] is disabled in the <Shaped Video> group
of the DME >Input/Output >Video/Key menu (4162),
the wipe crop effect cannot be obtained if [Bkgd] is not
enabled in the DME >Input/Output >Bkgd menu (4161).
Applying the wipe crop effect
To select a pattern
1
Open the DME >Edge >Wipe Crop menu (4116).
2
Press [Wipe Crop], turning it on.
3
Press [Pattern Select].
The Pattern Select menu (4116.1) appears.
4
From the displayed patterns (standard wipe patterns 1
to 24 and 304), press any pattern to select it.
You can adjust the size of the pattern using the [Size]
parameter.
To set the pattern size and position
1
In the Wipe Crop menu (4116), press [Position/Size].
2
Set the following parameters.
No. Parameter Adjustment
1 H
2 V
3 Size
5 Pattern
Note
When pattern number 304 is selected, the <Edge>
group effect varies according to the [Size] parameter
setting.
To invert the regions with video signal inserted
and not inserted
In the DME >Edge >Wipe Crop menu (4116), press
[Invert], turning it on.
To set the radius of pattern corners
You can set the radius of the four corners when wipe
pattern 304 is selected.
Note
This setting is available only when the signal format is
1080i/59.94 or 1080i/50.
1
In the Wipe Crop menu (4116), press [Radius].
2
Set the following parameter.
No. Parameter Adjustment
1 Radius
Setting the aspect ratio of the wipe crop
pattern (Aspect)
1
In the Wipe Crop menu (4116), press [Aspect].
2
Set the following parameters.
217
Horizontal position
Vertical position
Pattern size
Pattern number
Corner radius