Settings Relating To Keys, Wipes, Frame Memory, And Color Correction; Setting The Video Process Memory; Setting Show Key; Setting The Key Auto Drop Function - Sony XVS Series User Manual

Setting the DME wipe edge softness
function
You can display the input image filling the frame when
executing a DME wipe by disabling the edge softness
function.
Notes
• This setting is available only when the signal format is
1080i/59.94 or 1080i/50.
• When side flags are enabled, this setting is available only
when [16:9] is selected in the <Aspect> group in the
Engineering Setup >Switcher >Config >Side Flags
menu (7331.7).
In the Engineering Setup >Switcher >Transition menu
(7334), press [Full Size Edge Soft] to enable or disable.
Disabling will disable the edge softness function in any of
the following cases.
• When [Crop] is disabled in the <Crop Mode> group in
the DME Wipe >Modify menu of each switcher bank
• When [Crop] is enabled in the <Crop Mode> group in
the DME Wipe >Modify menu of each switcher bank
and the Top and Right parameters are set to "100.00" and
the Left and Bottom parameters are set to "–100.00"
• When the DME wipe direction is reverse and before
execution of the transition
Settings Relating to Keys,
Wipes, Frame Memory,
and Color Correction

Setting the Video Process Memory

To enable video process memory, in the Engineering Setup
>Switcher >Key/Wipe/FM/CCR menu (7335), press
[Video Proc Memory], turning it on.

Setting Show Key

1
In the Engineering Setup >Switcher >Key/Wipe/FM/
CCR menu (7335), press [Show Key].
The Show Key menu (7335.1) appears.
2
In the <Show Key Enable> group, select the target
signal to set.
3
To set the length of time the key is displayed, press
[Hold Time].
4
Set the following parameter.
No. Parameter Adjustment
1 Hold Time

Setting the Key Auto Drop Function

The "key auto drop" function automatically switches off a
particular key when you press a cross-point button in a bus
that outputs the background on the particular switcher
bank.
When the background output bus is in flip-flop mode, this
is always the A bus. In bus fixed mode, it is either the A
bus or the B bus, depending on the fader lever position.
For details, see "Flip-flop mode and bus fixed mode"
(page 90).
1
In the Engineering Setup >Switcher >Key/Wipe/FM/
CCR menu (7335), press [Key Auto Drop].
The Key Auto Drop menu (7335.2) appears.
2
Press the button for the key you want to turn off
automatically, turning the button on.
413
Show key hold time (frames)