How To Install The Scc Reader Cable - Sun Microsystems Sun Fire V440 Parts Installation And Removal Manual

How to Install the SCC Reader Cable

Before You Begin
Complete this task:
"How to Remove the SCC Reader Cable" on page 139
What to Do
Caution – The system supplies power to the system configuration card reader cable
even when the system is powered off. To avoid personal injury or damage to the
system, you must disconnect the AC power cords before servicing the system
configuration card reader cable.
1. Connect the SCC reader cable at J18 on the SCC reader.
Push the cable end into the connector.
2. Connect the SCC reader cable at P19 on the connector board.
Push the cable end into the connector.
J18
P19
Chapter 7 Servicing Cables 141