How to Install the Top Cover
Before You Begin
Complete this task:
"How to Remove the Top Cover" on page 34
What to Do
1. Insert the back edge of the top cover under the lip on the back panel.
2. Grasp the latches and lower the top cover onto the chassis.
3. Release the latches when the top cover is seated on the chassis.
4. Verify that the latches are engaged by gently pulling up on the sides of the top
cover.
5. Tighten the Phillips No. 2 captive lockdown screw that secures the top cover to
the chassis.
The lockdown screw is located on the chassis face above the disk drives.
6. Close and lock the system doors.
What Next
To power on the system, see:
"How to Slide the System Into the Cabinet" on page 32
"How to Power On the System" on page 19
Chapter 2 Preparing to Service the System
35