How To Remove The System From The Cabinet - Sun Microsystems Sun Fire V440 Parts Installation And Removal Manual

How to Remove the System From the
Cabinet
You can perform all service procedures while the system is still attached to the rails
extended from the cabinet. If you want to remove the system from the cabinet for
any other reason, follow the instructions in this section.
Caution – The system is heavy. Two persons are required to remove the system
from the cabinet in the following procedure.
Before You Begin
Complete these tasks:
Identify a helper to assist you in removing the system.
Verify that your helper can safely lift and carry 40 lb (18 kg), which is
approximately half the weight of a fully equipped system.
Review the steps in the next section with your helper and discuss how to
coordinate your efforts to ensure your mutual safety.
Assemble the correct tools for the procedure. See "Tools Required for Installation
and Service" on page 18.
Turn off system power. See "How to Power Off the System" on page 23.
Open and remove the cabinet front door and back door.
Caution – When completing a two-person procedure, always communicate your
intentions clearly before, during, and after each step to minimize confusion.
36 Sun Fire V440 Server Parts Installation and Removal Guide • July 2003