6. Install the AC inlet assembly.
a. Place the AC inlet assembly into the system, aligning the faceplace with the
chassis back panel.
b. Secure the AC inlet assembly faceplate to the chassis with the two Phillips
No. 2 captive screws.
c. Secure the AC cables to the side of the chassis using the two tie wraps
provided.
d. Connect the P13 rear LED power cable end to its connector on the side of the
chassis.
e. Secure the LED cable using the tie wrap provided.
Rear LED power cable
AC inlet faceplate
Tie wraps
Chapter 5 Servicing the Motherboard Components
111