How To Slide The System Out Of The Cabinet - Sun Microsystems Sun Fire V440 Parts Installation And Removal Manual

How to Slide the System Out of the
Cabinet
This procedure describes placing the system in position for service by sliding it out
of the cabinet without removing it from the rack. All service procedures can be
performed while the system is still attached to the rack.
Note – Sliding the system out of the cabinet is not required for servicing disk drives
or power supplies.
Before You Begin
Caution – Unless the cabinet is bolted to the floor, you must extend the cabinet's
anti-tip legs and adjust their stabilizing feet to the floor. You must level and secure
the cabinet to provide a safe working environment. See "Tools Required for
Installation and Service" on page 18 for tools required for this procedure.
What to Do
1. Extend and adjust the cabinet's anti-tip legs.
2. Open (or remove) the front and back cabinet doors.
3. Note each cable's origin and its terminating connection.
4. Disconnect all external cables from the back panel of the system.
Caution – Do not disconnect the power cords from the system power inlets unless
you are installing or replacing the motherboard, the connector board, the SCSI
backplane, the system configuration card reader, or the Advanced Lights Out
Manager (ALOM) system controller card. The power cords ground the system.
Chapter 2 Preparing to Service the System 29