Sun Microsystems Sun Fire V440 Parts Installation And Removal Manual page 146

2. Connect the P4 SCSI data cable end at P4 on the SCSI backplane.
Connect the cable before you install the SCSI backplane into the system.
3. Place the SCSI backplane into the system so the metal tabs on the bottom of the
chassis align with the holes in the bottom of the SCSI backplane.
Make sure that the two Phillips No. 2 captive screws align with their screw holes.
Note –
backplane at this point in the installation.
4. Tighten the two Phillips No. 2 captive screws that secure the SCSI backplane to
the chassis.
P4
P4
134 Sun Fire V440 Server Parts Installation and Removal Guide • July 2003
Make sure that the connector board does not come in contact with the SCSI