How To Install A Power Supply Using The Hot-Plug Operation - Sun Microsystems Sun Fire V440 Parts Installation And Removal Manual

What Next
To install a power supply using the hot-plug operation, see:
"How to Install a Power Supply Using the Hot-Plug Operation" on page 55
How to Install a Power Supply Using the
Hot-Plug Operation
The system's power supply hot-plug feature enables you to insert a power supply
without shutting down the operating system or turning off the system power.
When installing a power supply, you must insert the power supply and wait for the
two green power supply LEDs to light.
The following procedure assumes that you are accessing the system console by the
default method of connecting to the serial management port (SERIAL MGT) of the
Sun Fire V440 server.
Before You Begin
Note – You have limited time to perform a power supply hot-plug operation. You
have 10 minutes at sea level and a maximum of 7 minutes at 10,000 feet (3048
meters) to ensure proper system cooling.
Complete this task:
"How to Remove a Power Supply Using the Hot-Plug Operation" on page 52
What to Do
1. Make sure that the Phillips No. 2 captive screw on the new power supply is
completely unlocked.
Turn the screw counterclockwise until the side locking lever is fully contained in the
power supply.
2. Align the new power supply with its bay.
Chapter 3 Servicing the Front Panel Removable Devices 55