Sun Microsystems Sun Fire V440 Parts Installation And Removal Manual page 68

3. Slide the new power supply into the power supply bay until the power supply
connectors start to engage the connectors on the motherboard.
4. Push firmly on the front of the power supply to engage the power supply
connectors with the motherboard connectors.
Make sure that the power supply is fully seated by aligning the front of the power
supply with the scribe line on the bottom of the power supply bay.
5. Tighten the Phillips No. 2 captive screw to secure the power supply to the chassis.
Turn the screw until it stops to tighten it completely.
What Next
Verify that the power supply is operating correctly. Check the Service Required,
Standby Available, and Power OK LEDs on the power supply. You should hear the
power supply fan start spinning and the two green LEDs should light within three
seconds after completing a hot-plug installation. For more information about the
power supply LEDs, see:
"Power Supply LEDs" on page 6
To reassemble the system, close and lock the system doors.
56 Sun Fire V440 Server Parts Installation and Removal Guide • July 2003